| 2000 №03 (02) | 2000 №03 (04) |
The Paton Welding Journal, 2000, #3, 15-17 pages
Optimization of the heat source location in glow-discharge bonding
G.P. Bolotov
Chernigiv Technological Institute, Chernigiv, UkraineAbstract
The method proposed for analytical estimation of the optimal location, with respect to a joint, of the zone affected by the normally distributed heat source, i. e. medium-pressure glow discharge, is based on analysis of distribution of heat flows in parts joined. The method allows the time consumed for pre-production experimental-technological works to be reduced and waste of expensive materials to be avoided.
Keywords: bonding, glow discharge, dissimilar materials, parts of different sizes, heat source location, heating
References
1. Kochergin, A.K., Shestakov, A.I. (1971) Pressure bonding of metals with a low degree of distortion. Leningrad: LDNTP.2. Kochergin, A.K. (1967) The use of heating screens for diffusion bonding of metals. In: Bonding in radio electronics and instrument making. Leningrad: LDNTP.
3. Kvasha, A.N., Medvedev, D.N., Nichushkin, V.V. (1968) Investigation and development of the technology for vacuum diffusion bonding of bimetal inserts in pipings of alloys greatly differing in melting points. In: Proc, of the V Inter-University Sci. and Techn. Conf, on Vacuum Diffusion Bonding of Metals, Alloys and Non-Metallic Materials. Moscow: PNILDSV.
4. (1981) Diffusion bonding of materials. Handbook. Edited by N.F. Kazakov. Moscow: Mashinostroyeniye.
5. Chernysh, V.P., Bolotov, G.P., Kotelnikov, D.I. et al. (1984) Calculation of a heating temperature in glow-discharge diffusion bonding. Avtomaticheskaya Svarka, 9, 54 - 56.
6. Rykalin, N.N. (1951) Calculation of heat processes in welding. Moscow: Mashgiz.
7. Rabkin, D.M., Ryabov, V.R., Gurevich, S.M. (1975) Joining of dissimilar metals. Kyiv: Tekhnika.
8. (1970) Theory of welding processes. Edited by V.V. Frolov. Moscow: Vysshaya Shkola.