Print
2014 №06 (19) DOI of Article
10.15407/tpwj2014.06.20
2014 №06 (21)


TPWJ, 2014, #6-7, 95-96 pages  
FLUX-CORED WIRES FOR SURFACING OF STEEL HOT MILL ROLLS
 
Journal                    The Paton Welding Journal
Publisher                 International Association «Welding»
ISSN                       0957-798X (print)
Issue                       № 6-7, 2014 (June-July)
Pages                      95-96
 
 
Authors
I.A. KONDRATIEV and I.A. RYABTSEV
E.O. Paton Electric Welding Institute, NASU. 11 Bozhenko Str., 03680, Kiev, Ukraine. E-mail: office@paton.kiev.ua
 
 
Abstract
The flux-cored wires and technologies of arc surfacing of steel hot mill rolls were developed. The results of investigations and practical experience allows recommending the developed flux-cored wires for surfacing of steel rolls of the following mills: for roughing (blooming and slab) - PP-Np-25Kh5MSGF; for continuous billet - PP-AN147, PP-Np-35V9Kh3GSF; for heavy-section and rail-beam - PP-Np-25Kh5MSGF; for medium- and light-section - PP-Np-25Kh5MSGF, PP-AN147, PP-AN204; for wire - PP-Np-35V9Kh3GSF, PP-AN132; for sheet - PP-AN132, PP-Np-25Kh5MSGF; for pipe ones - PP-AN147, PP-Np-35V9Kh3GSF. 3 Ref., 1 Table, 1 Figure.
 
 
Keywords: arc surfacing, flux-cored wires, mill rolls, hot hardness, heat resistance, wear resistance
 
 
Received:                09.04.14
Published:               28.09.14
 
References
1. Ryabtsev, I.A., Kondratiev, I.A. (1999) Mechanized electric arc surfacing of metallurgical equipment parts. Kiev: Ekotekhnologiya.
2. Kondratiev, I.A. (1994) Self-shielded flux-cored wire for surfacing of maraging steel layer. Avtomatich. Svarka, 1, 49-51.
3. Kondratiev, I.A., Ryabtsev, I.A., Chernyak, Ya.P. (2006) Flux-cored wire for surfacing of maraging steel layer. Ibid., 4, 50-53.