Print

2015 №06 (11) DOI of Article
10.15407/tpwj2015.06.12
2015 №06 (13)

The Paton Welding Journal 2015 #06
The Paton Welding Journal, 2015, #5-6, 52-54 pages  

Peculiarities of fire-cracker plate electrode arc surfacing over alloying charge

I.A. Bartenev


Karaganda State Technical University. 56 Mir Bld., 100027, Karaganda, Kazakhstan. E-mail: igor_svar@mail.ru
 
 
Abstract
The method of arc surfacing of flat parts using fire-cracker plate electrode over alloying charge was offered. The main factors determining stability of surfacing process are the following: arc voltage U, arc current I, and electrode sectional area S. As a result of experiments the range of surfacing current (300-400 A) was determined providing stability of mode at the start and throughout the whole process of surfacing. It was established that hardness of deposited metal amounted to HRC 47-52, which is higher than that of metal such as steel G13. Metallographic investigations showed that the offered method provides a minimal penetration of base metal, that will allow obtaining the necessary chemical composition of deposited metal in single-layer surfacing. 4 Ref., 2 Tables, 3 Figures.
 
 
Keywords: arc surfacing, alloying charge, plate electrode, hardness of deposited metal, penetration
 
 
Received:                20.04.15
Published:               28.07.15
 
 
References
1. Vlasov, V.M. (1987) Serviceability of reinforced friction surfaces. Moscow: Mashinostroenie.
2. Livshits, L.S., Grinberg, N.A., Kurkumelli, E.G. (1969) Principles of alloying of deposited metal. Moscow: Mashinostroenie.
3. Frumin, I.I. (1961) Automatic electric arc surfacing. Kharkov: Metallurgizdat.
4. Ryabtsev, I.A., Kondratiev, I.A. (1999) Mechanized electric arc surfacing of metallurgical equipment parts. Kiev: Ekotekhnologiya.

Suggested Citation

I.A. Bartenev (2015) Peculiarities of fire-cracker plate electrode arc surfacing over alloying charge. The Paton Welding J., 06, 52-54.