Print

2014 №12 (07) DOI of Article
10.15407/tpwj2014.12.08
2014 №12 (09)

The Paton Welding Journal 2014 #12
The Paton Welding Journal, 2014, #12, 36-40 pages  

Application of complex-alloyed powders produced by thermocentrifugal sputtering in flux-cored wires

A.P. Zhudra, S.Yu. Krivchikov And V.I. Dzykovich


E.O. Paton Electric Welding Institute, NASU. 11 Bozhenko Str., 03680, Kiev, Ukraine. E-mail: office@paton.kiev.ua
 
 
Abstract
This paper presents the results of evaluation of the influence of complex-alloyed powders (CAP) on welding-technological properties of flux-cored wires and deposited metal performance. Possibility of ensuring a high degree of flux-cored wire alloying at reduction of its diameter is considered. Tribotechnical characteristics of metal deposited with flux-cored wires are determined at CAP application as a filler. The paper presents the results of metallographic investigations of deposited metal. It is established that CAP application as flux-cored wire core is favourable for the mode of electrode metal melting and transfer leading to improvement of their welding-technological characteristics. Wear resistance studies of deposited metal showed an improvement of wear resistance of deposited metal operating under the conditions of abrasive wear and metal-over-metal friction. 4 Ref. 5 Tables. 3 Figures.
 
 
Keywords: flux-cored wire, thermocentrifugal sputtering of ingots, complex-alloyed powders, welding-technological characteristics of flux-cored wire, tribotechnical characteristics of deposited metal
 
 
Received:                22.09.14
Published:               29.12.14
 
 
References
1. Kondratiev, I.A. (1980) Flux-cored wire filled by granular alloy. In: Theoretical and technological principles of surfacing. Surfacing of metallurgical and power engineering parts. Kiev: PWI.
2. Dzykovich, V.I. (2010) Study and development of materials for wear-resistant surfacing based on spheroidized granules of tungsten carbides: Syn. of Thesis for Cand. of Techn. Sci. Degree. Kiev.
3. Yuzvenko, Yu.A., Gavrish, V.A., Marienko, V.Yu. (1979) Laboratory units for evaluation of wear resistance of deposited metal. In: Theoretical and technological principles of surfacing. Properties and tests of deposited metal. Kiev: PWI.
4. Zhudra, A.P., Krivchikov, S.Yu., Petrov, V.V. (2004) Selection of boron-containing charge materials for the core of flux-cored wire. The Paton Welding J., 4, 51-52.

Suggested Citation

A.P. Zhudra, S.Yu. Krivchikov And V.I. Dzykovich (2014) Application of complex-alloyed powders produced by thermocentrifugal sputtering in flux-cored wires. The Paton Welding J., 12, 36-40.