Eng
Ukr
Rus
Print

2016 №10 (09) DOI of Article
10.15407/tpwj2016.10.10
2016 №10 (01)

The Paton Welding Journal 2016 #10
TPWJ, 2016, #10, 46-47 pages
 
Influence of technological factors of microplasma spraying of TiO2 on the degree of spraying material utilization


Journal                    The Paton Welding Journal
Publisher                 International Association «Welding»
ISSN                      0957-798X (print)
Issue                       #10, 2016 (October)
Pages                      46-47
 
 
Authors
Yu.S. Borisov, S.G. Vojnarovich, A.N. Kislitsa and S.N. Kalyuzhny
E.O. Paton Electric Welding Institute, NASU 11 Kazimir Malevich Str., 03680, Kiev, Ukraine. E-mail: office@paton.kiev.ua
 
 
Abstract
The work is a study of the degree of the influence of technological parameters of microplasma spraying on the coefficient of material utilization during formation of a resistive coating from titania. Investigations were conducted with application of a multifactorial experiment with fractional replicas 24–1. As a result of processing of experimental data, a regression equation was derived, which allows assessment of the degree of the influence of microplasma spraying parameters, such as current, spraying distance, plasma gas flow rate and powder consumption on the value of the material utilization coefficient. It is established that current value has the greatest influence on it. During investigations it was shown that selection of the parameters of microplasma spraying of resistive paths from TiO2 powder will allow minimizing material losses. 4 Ref., 2 Tables.
 
Keywords: microplasma spraying, TiO2,material utilization coefficient, resistive heating element
 
 
Received:                16.06.16
Published:               23.10.16
 
 
References
  1. Anshakov, A.S., Kazanov, A.M., Urbakh, E.K. et al. (1998) Development of low-temperature heater by plasma cladding method. Fizika i Khimiya Obrabotki Materialov, 3, 56–61.
  2. Baklanov, D.I., Belyajkov, I.N., Virnik, A.M. et al. Method of manufacture of resistance heating element. Pat. 2066514 RF. Int. Cl. H 05 B 3/12. Moscow: In-te for High Temperatures. Fill. 14.09.1993. Publ. 10.09.1996.
  3. Ershov, A.A., Urbakh, E.K., Faleev, V.A. et al. (1995) Plasma cladding of resistive layers of electric tape. In: of Conf. on Physics of Low-Temperature Plasma. Petrozavodsk: PGU, 1995, Pt 3, 409–411.
  4. Borisov, Yu.S., Vojnarovich, S.G., Kislitsa, A.N. et al. (2013) Manufacture of resistance electrical heater by microplasma cladding process. The Paton Welding J., 9, 50–51.