The Paton Welding Journal, 2011, №08



2011 №08 (10)

2011 №08 (12)

---

The Paton Welding Journal, 2011, #8, 42-45 pages  

PECULIARITIES OF TEMPERATURE DISTRIBUTION IN THIN-SHEET ALUMINIUM ALLOY AMg5M IN FRICTION STIR WELDING

A.G. POKLYATSKY

E.O. Paton Electric Welding Institute, NASU, Kiev, Ukraine
 
 
Abstract
Influence of backing material, speed of welding and diameter of tool shoulder on the change in nature of temperature distribution in welded joint cross-section was studied. It was established that formation of permanent joints in friction stir welding takes place at the temperature of not higher than 450 °C.
 
 
Keywords: friction stir welding, aluminium alloy AMg5M, thin sheet, butt joints, thermal cycle, distribution of temperatures
 
 
Received:                ??.??.??
Published:               28.08.11
 
 
References
1. Lambrakos, S.G., Fonda, R.W., Milewski, J.O. et al. (2003) Analysis of friction stir welds using thermocouple measurements. Sci. and Techn. of Welding and Joining, 5, 385-390.
2. Shercliff, H., Russel, M., Taylor, A. et al. (2005) Microstructural modeling in friction stir welding of 2000 series aluminium alloys. Mechanique and Industries, 6, 25-35.
3. Kokubo, M., Takayama, Y., Kazui, S. et al. (2007) Temperature analysis in friction stir welding of ADC12/5052 dissimilar aluminium alloys. J. Japan Institute of Light Metals, 11, 511-517.
4. Colegrove, P.A., Shercliff, H.R. (2003) Experimental and numerical analysis of aluminium alloy 7075-T7351 friction stir welds. Sci. and Techn. of Welding and Joining, 5, 360-368.
5. Khandkar, M.H., Khan, J.A., Reynolds, A.P. (2003) Prediction of temperature distribution and thermal history during friction stir welding: input torque based model. Ibid., 3, 165-174.
6. Cederqvist, L., Reynolds, A.P. (2001) Factors affecting the properties of friction stir welding aluminum lap joints. Welding J., 12, 281-287.
7. Hassan, A.A., Prangnell, P.B., Norman, A.F. et al. (2003) Effect of welding parameters on nugget zone microstructure and properties in high strength aluminium alloy friction stir welds. Sci. and Techn. of Welding and Joining, 4, 257-268.
8. Sato, Y. (2002) Relationship between mechanical properties and microstructure in friction stir welded Al alloys. J. JWS, 8, 33-36.
9. Chao, Y., Wang, Y., Miller, K. (2001) Effect of friction stir welding on dynamic properties of AA2024-T3 and AA7075-T7351. Welding J., 8, 196-200.
10. Okamura, H. (2003) Point of application for ESW. Welding Technology, 15, 60-69.

---

Suggested Citation

A.G. POKLYATSKY (2011) PECULIARITIES OF TEMPERATURE DISTRIBUTION IN THIN-SHEET ALUMINIUM ALLOY AMg5M IN FRICTION STIR WELDING. The Paton Welding J., 08, 42-45.

---