The Paton Welding Journal, 2011, №11



2011 №11 (03)

2011 №11 (05)

---

The Paton Welding Journal, 2011, #11, 15-18 pages  

DEVELOPMENT OF FLUX-CORED WIRE FOR ARC WELDING OF HIGH-STRENGTH STEEL OF BAINITE CLASS

V.N. SHLEPAKOV, Yu.A. GAVRILYUK and S.M. NAUMEJKO

E.O. Paton Electric Welding Institute, NASU, Kiev, Ukraine
 
 
Abstract
Given are the results of investigation of the effect of alloying on formation of structure and mechanical properties of the weld metal in gas-shielded flux-cored wire welding, as well as of development of composition of a core of the wire providing the yield strength value of not less than 590 MPa and impact energy of more than 50 J at -50 °C. Optimal additional microalloying with zirconium was determined for the basic C-Si-Mn-Ni-Mo alloying system. This microalloying allows decreasing the volume fraction and size of non-metallic inclusions, as well as increasing the share of dispersed components in metal structure, and provides the required level of strength of the weld metal and its low-temperature tough-ductile properties.
 
 
Keywords: arc welding, low-alloy steel, flux-cored wires, properties of weld metal, structure, non-metallic inclusions, microalloying
 
 
Received:                ??.??.??
Published:               28.11.11
 
 
References
1. Gorynin, I.V., Malyshevsky, V.A., Legostaev, Yu.L. et al. (1996) High-strength steels for hulls, marine structures and deep-water technique. Progres. Materialy i Tekhnologii, 2, 23-24.
2. Thomson, S.W., Krauss, G. (1996) Austenite decomposition during continuous cooling of HSLA-80 plate steel. Metallurg. and Materials Transactions A, 27(June), 1557-1571.
3. Tailor, D.J., Evans, G.M. (1983) Development of MMA electrodes for offshore fabrication. Metal Constr., 15(8), 438-443.
4. Zhang, Z., Farrar, R.A. (1997) Influence of Mn and Ni on microstructure and toughness of C-Mn-Ni weld metals. Welding J., 76(5), 183-190.
5. Wang, W., Liu, S. (2002) Alloying and microstructural management in developing SMAW electrodes of HSLA-100 steel. Ibid., 81(7), 132-145.
6. Grabin, V.F. (1982) Materials science of fusion welding. Kiev: Naukova Dumka.
7. Grigorenko, G.M., Kostin, V.A., Golovko, V.V. et al. (2004) Effect of chemical inhomogeneity on the formation of acicular ferrite in high-strength weld metal. The Paton Welding J., 4, 2-7.

---

Suggested Citation

V.N. SHLEPAKOV, Yu.A. GAVRILYUK and S.M. NAUMEJKO (2011) DEVELOPMENT OF FLUX-CORED WIRE FOR ARC WELDING OF HIGH-STRENGTH STEEL OF BAINITE CLASS. The Paton Welding J., 11, 15-18.

---