Print

2012 №01 (06) 2012 №01 (08)

The Paton Welding Journal 2012 #01
The Paton Welding Journal, 2012, #1, 26-28 pages  

MANUFACTURE OF STAINLESS STEEL-ALUMINUM TRANSITION PIECES BY VACUUM PRESSURE WELDING METHOD

G.K. KHARCHENKO1, Yu.V. FALCHENKO1, V.E. FEDORCHUK1, S.G. GRIGORENKO1 and M.M. RUDENKO2


1E.O. Paton Electric Welding Institute, NASU, Kiev, Ukraine
2Chernigov State Technical University, Chernigov, Ukraine
 
 
Abstract
Technology of vacuum pressure welding of bimetal tubular transition pieces from 10Kh18N10T stainless steel with AD1 aluminum was developed. It is established that modifying the steel blank surface using holes promoted localizing of plastic deformation in the butt joint and producing welded joints with the strength not lower than that of aluminum.
 
 
Keywords: vacuum pressure welding, bimetal joint, aluminum AD1, steel 10Kh18N10T, transition piece, microstructure
 
 
Received:                25.09.11
Published:               28.01.12
 
 
References
1. Bachin, V.A., Kvasnitsky, V.F., Kotelnikov, D.I. et al. (1991) Theory, technology and equipment of diffusion welding. Moscow: Mashinostroenie.
2. (1981) Diffusion welding of materials: Refer. book. Ed. by N.F. Kazakov. Moscow: Mashinostroenie.
3. Kopylov, Yu.N., Kazakov, N.F., Grishin, I.S. et al. (1973) About formation of joints in vacuum diffusion welding. In: Proc. of 7th All-Union Sci.-Techn. Conf. on Vacuum Diffusion Bonding of Metals, Alloys and Nonmetallic Materials (Moscow, May 1973), 12-25.
4. Musin, R.A., Lyamin, Ya.V. (1991) Intensification of plastic deformation of inserts in diffusion welding. Avtomatich. Svarka, 8, 26-29.
5. Musin, R.A., Lyamin, Ya.V. (1994) Deformability of perforated inserts in diffusion welding. Svarochn. Proizvodstvo, 6, 24-26.
6. Lyamin, Ya.V. (1998) Development of methods for intensification of diffusion welding process and increase in strength of cermet joints: Syn. of Thesis for Cand. of Techn. Sci. Degree. Perm.
7. Ternovsky, A.P., Karakozov, E.S., Zimidchenko, S.S. (1983) Specifics of formation of dissimilar metal joints in diffusion welding by scheme of forced deformation. Avtomatich. Svarka, 3, 31-34.
8. Konyushkov, G.V., Kopylov, Yu.N. (1974) Diffusion welding in electronics. Moscow: Energiya.

Suggested Citation

G.K. KHARCHENKO1, Yu.V. FALCHENKO1, V.E. FEDORCHUK1, S.G. GRIGORENKO1 and M.M. RUDENKO2 (2012) MANUFACTURE OF STAINLESS STEEL-ALUMINUM TRANSITION PIECES BY VACUUM PRESSURE WELDING METHOD. The Paton Welding J., 01, 26-28.