The Paton Welding Journal, 2014, №09



2014 №09 (02)

DOI of Article 10.15407/tpwj2014.09.03

2014 №09 (04)

---

The Paton Welding Journal, 2014, #9, 25-29 pages  

EFFECT OF ELECTRIC PARAMETERS OF ARC SURFACING USING FLUX-CORED WIRE ON PROCESS STABILITY AND BASE METAL PENETRATION

Yu.N. LANKIN, I.A. RYABTSEV, V.G. SOLOVIOV, Ya.P. CHERNYAK and V.A. ZHDANOV

E.O. Paton Electric Welding Institute, NASU. 11 Bozhenko Str., 03680, Kiev, Ukraine. E-mail: office@paton.kiev.ua
 
 
Abstract
Effect of electric parameters of arc surfacing using self-shielding flux-cored wires on process stability and base metal penetration was investigated. The experiments were carried out with computer registration of electric parameters of surfacing. The results of oscillogram processing were used for plotting of Iw and Uw diagrams with outlined areas of stable process of surfacing, short circuits and arc extinctions. Coefficient of process instability g was derived from received real parameters of arc surfacing using flux-cored wire. It is determined that voltage has the largest effect on stability indices and its rise improves process stability. Effect of modes of surfacing on penetration and portion of base metal in the deposited metal was investigated. 3D chart was plotted on estimation results. An area of optimum modes, providing sufficient stability of the process at minimum penetration and good formation of deposited beads, is outlined. 4 Ref., 2 Tables, 7 Figures.
 
 
Keywords: arc surfacing, flux-cored wire, stability of surfacing process, instability coefficient, base metal penetration, portion of base metal
 
 
Received:                06.03.14
Published:                28.09.14
 
 
References
1. Frumin, I.I. (1961) Automatic electric arc surfacing. Kharkov: Metallurgizdat.
2. Ryabtsev, I.A., Kondratiev, I.A., Babinets, A.A. et al. (2012) Effect of high-temperature thermal cycling on deposited metal of the type of heat-resistant die steels. The Paton Welding J., 2, 22-24.
3. Senchenkov, I.K., Chervinko, O.P., Ryabtsev, I.A. et al. (2013) Determination of service resource of surfaced parts under cyclic, thermal and mechanic loads. Svarochn. Proizvodstvo, 1, 8-3.
4. Yuzvenko, Yu.A., Kirilyuk, G.A. (1973) Surfacing with flux-cored wire. Moscow: Mashinostroenie.

---

Suggested Citation

Yu.N. LANKIN, I.A. RYABTSEV, V.G. SOLOVIOV, Ya.P. CHERNYAK and V.A. ZHDANOV (2014) EFFECT OF ELECTRIC PARAMETERS OF ARC SURFACING USING FLUX-CORED WIRE ON PROCESS STABILITY AND BASE METAL PENETRATION. The Paton Welding J., 09, 25-29.

---